Easily test all critical functions using the QA-ES III electrosurgery analyzer and tester. Quickly collect all measurements, including vessel sealing, contact quality monitor (CQM), high frequency (HF) leakage and output power distribution (single or continuous mode) with the easy-to-use interface guide.
Key Features:
- Test all critical functions of the Electrosurgical Unit (ESU) with precise ranges of power, current, frequency, crest factor and load resistance
- Collect measurements in single and continuous mode
- Comply with all global standards, including ANSI/AAMI and IEC**
- All-in-one: all hardware and software tools necessary to complete preventive maintenance and troubleshooting are integrated into the unit, eliminating the need to purchase or transport additional cables, wires, switch boxes and RECM boxes
- Easy-to-use interface: large buttons and LCD screen guide the user through test sequences
- Memory storage of up to 5,000 test records, eliminating the need to download data after completion of each preventive maintenance or troubleshooting session
- Bipolar leakage test performed with fixed 200 ohm load.
Test all critical functions of the Electrosurgical Unit (ESU) with precise ranges of power, current, frequency, crest factor and load resistance, ensuring ESU safety. Ensure performance and safety of electrosurgical units with simplified testing using the QA ES III electrosurgery analyzer and tester. The QA-ES III is capable of testing all modern high-power electrosurgical units, with generator output current accuracy as low as ± 2.5%. Collect all measurements, including vessel sealing, contact quality monitor (CQM), high frequency (HF) leakage and output power distribution in single or continuous mode. You don’t need to carry additional accessories or cables, as the QA-ES III has all the hardware and software features necessary for complete testing. With all-in-one features, the QA-ES III is one of the most user-friendly electrosurgery analyzers on the market today. Additionally, the optional Ansur test automation software allows users to create and automatically run tests, capture data and produce easy-to-read reports.
10 Best Practices for Electrosurgical Unit Testing Continuous operation: Continuous measurement of power, current, peak-to-peak voltage (closed load only) and crest factor Single operation: Single measurement after set delay time of ESU output of power, current, peak-to-peak voltage (closed load only) and crest factor Power distribution: Tests impedance detection circuitry in power assurance functions in next-generation ESU units. Applicable parameters – power, current, peak-to-peak voltage (closed load only) and crest factor – can be easily observed during measurements RF leakage current: Provides load connections and configurations to measure HF leakage from grounded and isolated equipment RECQM: Tests return electrode control quality monitoring using QA-ES internal loads.
